1919 A4 Forums banner
1 - 4 of 4 Posts

Premium Member
2,823 Posts
Discussion Starter · #1 ·
I now have #7 Cobalt bits available in the bit sets. These are needed for the Top Plate rivet holes when using BlackBear rivet sets. I apologize for not offering them earlier, but I used a different company's rivet set on my build, and only recently realized a #7 bit was needed.

The link to the countersinks bits and rivet tool thread is:


To make it right to all of you out there with BB rivets, If you bought a bit set from me, I'll ship a #7 cobalt bit to you for $2.50. I'll offer this deal through the end of August 06.

I'm still working on providing another source for high quality 60 degree rivets. Most of them are custom stuff, and my source had a seasonal shutdown.

1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.