1919 A4 Forums banner
1 - 3 of 3 Posts

· Premium Member
5,337 Posts
Tools for the BAR

I have a copy of the BSD (Base Shop Data) for the BAR. It shows two specialzed tools for barrel/reciever assembly one is a block that clamps around the barrel to hold it in a vise the other is a wrench with very long jaws that fits over the top of the reciever to screw the reciever onto the barrel. These tools were designed and fabricated by the RIA for shop assembly.

I also have the drawings to make both tools, but they have been reduced in size.

If this would help pm or e-mail me
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.