1919 A4 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
293 Posts
Discussion Starter #1
Can I safely use internal parts machined for a US Ordnance right side plate in a Rapid fire gun. The internal parts fit no problem in the ORF gun. My Rapid fire gun lock frame right arm is cracked and the Rapid fire sear broke today. I swapped out the lock frame,bolt with KMP trigger and sear and fired 20 rounds in this set up with no issues. Can I go ahead and run a 250 round belt through it now without worry :) ? Thanks.
 

·
Registered
Joined
·
7,837 Posts
I guess I would lay them side by side and see if the machining is the same for the denial island. I would not be afraid to rip a belt through it if they are the same...
 

·
Registered
Joined
·
293 Posts
Discussion Starter #3
I guess I would lay them side by side and see if the machining is the same for the denial island. I would not be afraid to rip a belt through it if they are the same...
Yes the parts are almost identical I believe the parts are machined slightly larger but they fit in the receiver well.
 
1 - 3 of 3 Posts
Top