[Brass Cartridge]

Gentlemen,

I have a few plates left over from a run.

I sent e-mails to everyone who contacted me with interest when I first announced the run. If you sent funds in your plate(s) is(are) on the way.

If you didn't respond and/or did not send funds in, then it may well be your plate being sold here.

Price is $145 plus USPS shipping.

Plates do not have the holes drilled for the rear sight bracket. The holes are spotted on the inside of the plate. This will allow you to build the plate into an authentic looking 1919 OR 1917a1 plate.

Same quality you have come to expect from Halo Mfg.


Registered Right Hand Plates will follow soon. Just in time for your spring time builds and summer enjoyment...

E-mail me with interest in the Left hand plates: [email protected]

I will reply with total quotes including shipping to your home. Less than ten plates available and in stock... don't wait.

Michael

 

[dmsdog]

Payment on the way

 

[slipin & slidin]

What is the outcome of your 80% right side plates that you sold?
Are these buildable or can we expect to hand these over to A.T.F.

 

[42rocker]

Question left side plates

Michael
Do these left side plates have the 2 camming parts on the inside?

Later 42rocker

 

[southbysouthwest]

My new LHSPs for the 1917A1s just showed up and Halo's quality is impeccable as always..Thanks Michael for getting back on the horse!

 

[ajmdreammg42]

don't get worked up in a frenzy guys but I am sure Michael will fill in all the details of whats going on soon. personnaly I do not think we will get any knocks at the door about past 80 % plates sold. lets just wait till he is back and operational again. He still owes me a M2HB plate and I am waiting patiently for it.

 

[Lucky#13]

Michael
Do these left side plates have the 2 camming parts on the inside?

Later 42rocker

I hope Michael won't mind me answering for him on this. The cams are a separate item and must be obtained separately, or you can rob them off your 1919 side plate. Contact L999here, as he recently had some made.

If you need a new Belt Holding Pawl Bracket, I have those, rivets included.

MSG has rivets for the cams.