1919 A4 Forums banner
1 - 3 of 3 Posts

·
Moderator
Joined
·
12,515 Posts
Discussion Starter · #1 ·
as befitting the name might be, I want to return this dummy gun to life.
Last item needed are the action arm plates.

Are these normally cut, or replaced for semi builds? Hoping some semi builder has an extra set of the FA plates left over.

Rory
 

·
Registered
Joined
·
3,350 Posts
as befitting the name might be, I want to return this dummy gun to life.
Last item needed are the action arm plates.

Are these normally cut, or replaced for semi builds? Hoping some semi builder has an extra set of the FA plates left over.

Rory
Rory,

Good luck, they are really hard to find! I have not seen them sold as an individual part in a few years now.

You can use German Recoil plates! I have some spare sets if you need them. They should work the same. You will need to open up the lower feedblock slot. Remove one of the springs. However from the outside, it should look the same and function 100%. I use German recoil plates when converting my MG08s to 7.62x54r using 1910 feedblocks and locks and it works well.
 

·
Registered
Joined
·
4,955 Posts
Rory,

Good luck, they are really hard to find!
That is an understatement!!!
+1 for Matt and his Maxim parts, nobody has a better inventory and is better to deal with. :thumbup:
CaptMax
 
1 - 3 of 3 Posts
Top