1919 A4 Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,280 Posts
Discussion Starter · #1 ·
M2 Barrel Support with threaded bushing. Bushing not finish milled. Bronze bushing needs to be turned or milled to final ID for your barrel. Bushing will not go over .50 barrel. Hole in bushing too small, needs to be finished. The bronze part WILL NOT FIT, IT NEEDS TO BE FINISHED. Armasteel casting. One crack shown/repaired by someone before I got it (see it in the pic of the Armasteel mark). This support was part of my blank get-up when I had a 50. Get it while you can. The new overlords are going to crack down on used parts that rarely break or need servicing. Plus this one includes a bushing that will mean extra work for you! Fifty dollars shipped continental United States only.
First "ill take it" . Thanks for playing. J



 

·
Registered
Joined
·
7,252 Posts
...rats...!!!

...missed this one. Need a barrel support to finish an M2HB. And I just got my Bridgeport and South Bend lathe up and running TO DO SOME MACHINE WORK LIKE THIS.. tAKE SECONDS IF FIRST RESPONSE FALLS THROUGH.
 

·
Premium Member
Joined
·
1,304 Posts
FML...that was a steal.....got any more?
 
1 - 6 of 6 Posts
Top