1919 A4 Forums banner

1 - 10 of 10 Posts

·
Premium Member
Joined
·
1,341 Posts
Discussion Starter #1 (Edited)
Could someone share the drawing for the left plate for an M2hb with me? I have the right plate drawing, so I have all the basics, mainly looking for placement of hole for switch, and the placement of the cam under the switch which lifts the extractor. I also am looking for a drawing of the cam. Thanks
 

·
Premium Member
Joined
·
1,341 Posts
Discussion Starter #2
Ok Ive got most everything located and machined other than the correct location for the rivet holes for the cam that lifts the extractor in the left plate as the bolt come forward. If anyone can help me with the location of these two holes tonight it would be greatly appreciated.
 

·
Registered
Joined
·
2,417 Posts
Those look great thanks for posting. Are you going to grind out or blast out the machine marks or are you going to leave it the way it is? Just curious.
 

·
PhD in Over-Engineering
Joined
·
12,236 Posts
LH plates available from KMP, let's not forget. And Halo may be tooled up for those too, in the near future. These companies have been here supporting us for years now.
 
1 - 10 of 10 Posts
Top