[ajmdreammg42]

Ok some of you guys have your own mills out there, where do you send them to get sharpened and how much does it run ? got a whole tool box drawer full of them at a auction ( some carbide ones too) but most of them need resharpened.

 

[30calmachinegunner]

just look up Tool and cutter grinders in the business to business section of the phone book or on line, find one local if you can and be sure to try him out with a few of them first to see how he does before getting them all sharpened

 

[TARGSHOOT]

30 cal is correct, give them a few and see how well they do. ive been burnt on this before, ended up with scrap that would barely cut alum.