1919 A4 Forums banner

mill bit sharpened where ?

1185 Views 2 Replies 3 Participants Last post by  TARGSHOOT
Ok some of you guys have your own mills out there, where do you send them to get sharpened and how much does it run ? got a whole tool box drawer full of them at a auction ( some carbide ones too) but most of them need resharpened.
1 - 1 of 3 Posts
30 cal is correct, give them a few and see how well they do. ive been burnt on this before, ended up with scrap that would barely cut alum.:(
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.