1919 A4 Forums banner
1 - 2 of 2 Posts

· Registered
1,388 Posts
Discussion Starter · #1 ·
Well I just made a die for my press to load links, it works pretty well. I found an old aluminum die at a gun show, some aluminum rod at work. I drilled the rod so it would slip over the 308, then put it inside the die. Once it's position was determined I cross drilled both pieces and stuck a roll pin through it. Now I need to fab a vertical tray to hold the rounds upright to relieve strain on my hand and the links. I load twenty at a time then put them together. KevinT
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.