1919 A4 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
200 Posts
Discussion Starter #1
Good afternoon all, just finished countersinking the holes in the RSP. I have the 1919 all mocked up, rivets in place and I have one long skinny rivet left, what is it for? I have the two thick long rivets going through the trunnion, the one long skinny one going through the pintle pad and trunnion, and the other one going through the hole that is directly behind the top cover. So where does this third long skinny one go???
 

·
Registered
Joined
·
5,117 Posts
Its typically an alternate for the front of the top plate. If its one of MSG sets he usually supplies a domed one and a flat one so you have a choice
 
1 - 2 of 2 Posts
Top