just bend the extractor spring a bit by hand
your problem is most likely with too stiff of a belt holding pawl spring (the one on the trunnion that is held in place by the split pin)
its a pretty common problem - try searching for this on this forum
start by replacing that spring with one of much weaker rate and if that doesnt solve the problem, then come back and ask again
Mike
your problem is most likely with too stiff of a belt holding pawl spring (the one on the trunnion that is held in place by the split pin)
its a pretty common problem - try searching for this on this forum
start by replacing that spring with one of much weaker rate and if that doesnt solve the problem, then come back and ask again
Mike
