[ali059]

Hi,

I am looking for a RIA bolt in 30.06 with no 7.62 on it. Anyone have one?

Thanks

 

[Lucky#13]

Hi,

I am looking for a RIA bolt in 30.06 with no 7.62 on it. Anyone have one?

Thanks

Did you try my suggestion on your other thread? Joe H, aka mondragoon, should have one of these.

 

[P.W.Browning]

I've got a stripped one I would trade for an unmodified 'SG' bolt.

-Patrick

 

[ali059]

Lucky, no I did not see that. I'll try that. Thanks

I have an unmodified SG bolt BUT it has 7.62 on it.

 

[Lucky#13]

I have an unmodified SG bolt BUT it has 7.62 on it.

I think that is what he meant by "unmodified". No Izzy 7.62 mods.

P. W. Browning, try the same source if you want to purchase that SG bolt.

 

[Dave B - Great Lakes Arms]

You can also try Bob Leyshion Jr, goes by "Fullauto1919" here. Here is a snip from another post of his back on December 6, 2007


"New address is [email protected]. Sorry guys been busy with family stuff. Still have lots of Browning parts.

Best regards and Merry Christmas

Bob Leyshion, jr."


He has LOTS of Browning parts, give him a shout.

 

[ali059]

Hi,

Thanks guys, have not got around to it yet but I will contact those people! That's what I love about this site.

Someone on another post said this was a good old boy network, well if it is I am happy to be a part of it!

Hey Rollin,

I bet that you read this, if not I will be contacting you soon. I am building a RIA 1917 with one of Lou's spec'ed jackets I was wondering if you know if RIA ever built any that had the brass end caps and steel trunnion during WWII. Lou said it was possible. Was there any serial numbers that RIA used in WWII also?

Thanks!!!