1919 A4 Forums banner

Why are the rear top rivets rounded

2422 Views 12 Replies 10 Participants Last post by  Lucky#13
As I do my build I was wondering why the rear INSIDE top cover rivets are rounded and not flat? Would it be easier to hold them in place for riveting if they are flat? I know you grind one side to fit closer to the top of the top cover, but the end is rounded.

1 - 1 of 13 Posts
You all are missing something...no way to get into that top piece to cut a countersink because of the edges that hang down

1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.