1919 A4 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
520 Posts
Discussion Starter #1
I have the brass plugs that screw into the base of 60mm mortar illumination rounds, they are old and dirty but would clean up nice. they all have the internal floating firing pin except one. 73 of them for 365 dollars. shipped.

Thanks
 

·
Registered
Joined
·
256 Posts
Are these for the steel wwII type tail fins or the newer aluminum tail fins. If the are from the old steel tail fins how in the hell did you get them out? I have about 100 tail fins and have not found a way to get the brass "firing pins" out without drilling them out carefully. Are you set on cash or would you consider a trade?

Thanks,
Ben
 

·
Registered
Joined
·
520 Posts
Discussion Starter #3
Hey Ben,

You could drive down and check them out...they are out of steel fins. Unfortunately I am selling all my gun show collection stuff that was going to be a some day project because taxes hurt me at a very bad time...I really need the cash.
 
1 - 3 of 3 Posts
Top