1919 A4 Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
435 Posts
Discussion Starter #1 (Edited)
It has been "brought" to my attention that I have been accumulating too much. So, I must unfortunately sell half of my stockpile.

1. 9mm indoor range brass (some nickel), not tumbled. Approximately 19lbs = 2223 cases. Sold to Ruger

2. .40 S&W indoor range brass. Approximately 14lbs brass = 1400 cases, not tumbled. Approximately 8lbs nickel = 800 cases tumbled. Total 2200. SOLD

3. .45 ACP indoor range brass (some nickel) all large primer. Approximately 16lbs=1248 cases. Half are deprimed, so the cases count should be higher when individually counted. Sold to Brass

I prefer postal money orders, but personal check is okay (cleared first).

-Patrick
 

·
Registered
Joined
·
2,992 Posts
It has been "brought" to my attention that I have been accumulating too much. So, I must unfortunately sell half of my stockpile.

1. 9mm indoor range brass (some nickel), not tumbled. Approximately 19lbs = 2223 cases. $55 shipped.

2. .40 S&W indoor range brass. Approximately 14lbs brass = 1400 cases, not tumbled. Approximately 8lbs nickel = 800 cases. Total 2200. $55 shipped.

3. .45 ACP indoor range brass (some nickel) all large primer. Approximately 16lbs=1248 cases. Half are deprimed, so the cases count should be higher when individually counted. $60 shipped.

I prefer postal money orders, but personal check is okay (cleared first).

-Patrick
PM sent about brass
 

·
PhD in Over-Engineering
Joined
·
12,236 Posts

·
PhD in Over-Engineering
Joined
·
12,236 Posts
I actually acquired a couple of S/A Thompsons recently, so it looks like I'll be reloading a lot of .45 ammo in the near future.......:rolleyes:

I suspect it will be worth it tho......:D
Nice pick up! I have a Thompson project I want to get running soon. Doug Richardson Ultimax receiver, just a few whacks on the Bridgeport, some markings, a Form 2 and away we go! I don't think it will be possible to have enough .45 ACP ammo.....


So, it looks like the .45 is gone, the 9mm is gone? Hope the .40 has a buyer soon. Let's help this gentleman sell some brass!
 

·
Registered
Joined
·
7,837 Posts
Nice pick up! I have a Thompson project I want to get running soon. Doug Richardson Ultimax receiver, just a few whacks on the Bridgeport, some markings, a Form 2 and away we go! I don't think it will be possible to have enough .45 ACP ammo.....


So, it looks like the .45 is gone, the 9mm is gone? Hope the .40 has a buyer soon. Let's help this gentleman sell some brass!
Sometimes I envy you 02/07 guys.......and sometimes not. :) Your project will no doubt be more fun than mine Lucky#13. :D

I did get the brass and it looks great - thanks Patrick!
 
1 - 10 of 10 Posts
Top