WTs a bunch of kits and cut receivers
Join the discussion
Recommended Reading
-
WTB: Pintle for 1919
Misc Ad BoardJust need the small pintle that fits into the m2 tripod socket. Please send me an email (preferred) if you have one at [email protected] or IM me here. Thank you!- 23
- 389
-
WTS: IMI Uzi Full Size SMG with accessories, Bolt gun
Misc Ad BoardSelling a full size Uzi, transferable B&G Bolt gun, with accessories. In an IMI B gun, upgraded to full auto. Includes top cover with Burris Fastfire red dot, extended charging handle, spare barrel, threaded short barrel for suppressor. Vector drum, 50 round stick mag, six 30 round, two 25 round...- 2
- 97
-
WTS Early Import PPSh41 parts kit
Misc Ad BoardPPSh41 parts kit This is a very clean early import PPSH41 kit. The trunion is uncut and the barrel is intact. The rear latch assembly is still attached to the rear piece of the receiver. The two piece cleaning rod is not shown but is included (inside the buttstock). $400 shipped- 3
- 1K
-
WTS: MG42 Bolts, Belting machine, 8mm barrels $75, 300, 300
Misc Ad BoardYUGO M53/MG42 Bolts with anti bounce device , very good used condition. $75 8mm belting machine in can, YUGO production. $300 YUGO 8mm barrels, outstanding condition , most are still in grease. comes with carrier... $300 Shipping is: $10 bolts, $20 on barrels and belter . I’ll ship via...- 6
- 477
-
WTT: 30-06 Vickers barrel for .303 barrels
Misc Ad BoardI still have a couple 30-06 Vickers barrels to part with. Both I believe are new old stock. Chamber, bore, and rifling are clean and shiney shiney. The outside had surface rust with some light pitting. Most of the pitting has been polished out and hot blued (by me) so they look pretty nice and...- 0
- 60
-
Mike Duke · updated
Join now to ask and comment!