1919 A4 Forums banner
1 - 1 of 1 Posts

· Registered
47 Posts
Discussion Starter · #1 ·
Trunion has practically no wear on the feedway and has 9/16" bolt hole, has not been bored out for a repair bushing. There are also no casting marks on the bottom, it is completely machined smooth. SOLD

Bottom plate is not bent and grinder marks are not deep they will dress out just fine. They did however hit the top of the pin hole with the grinder as you can see in the first pic. SOLD
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.