1919 A4 Forums banner
1 - 1 of 1 Posts

· Registered
833 Posts
Discussion Starter · #1 ·

I have a dummy receiver for that MG42 or M53 parts kit you have just laying around. It is made from a plastic resin material and replaces the missing rear part so you can mock your gun up. The buttstock cliips on and all my parts fit fine, but may require some minor fitting as all parts kits are a little different. Asking $100 shipped or trade for the following:

-AK flats (prefer tapco, but any will work)
-AK parts kit
-C&R rifles
-other parts kits
-1917A1/ 1919A4 small parts (LSP, bottom/top plates, top cover parts, etc)
-Ammo (8mm, 30-06, 308)

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.